ARM Technical Support Knowledge Articles

ETM CONNECTOR PROBLEM

Applies to: MCB2300 Evaluation Board

Answer


Information in this article applies to:


QUESTION

The ETM connector on MCB2300 does not work on board revisions Ver 3.0 or before since it appears that the ETM pins are mirrored.

ANSWER

This is a known issue older MCB2300 Boards. MCB2300 Vers. 3.1 has a correct layout for the ETM connector.

SEE ALSO

ATTACHED FILES

Request the files attached to this knowledgebase article.

Article last edited on: 2007-07-24 10:40:57

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential