ARM Technical Support Knowledge Articles

CONDITIONAL BREAKPOINTS WITH STM32 DEVICES

Applies to: MCBSTM32 Evaluation Board

Answer


Information in this knowledgebase article applies to:


QUESTION

On my MCBSTM32 board, I want the debugger to break when a variable in my code equals a certain value, so I use the following debug command:

BS Write AD_DbgVal==0x00000041A, 1

But the debugger stops every time the AD_DbgVal value changes. What could be causing this?

ANSWER

STMicroelectronics has acknowledged that earlier versions of their STM32Fxxx devices may exhibit this behavior while debugging. This has been corrected in Rev Z of the STM32F103ZE device.

MORE INFORMATION

ATTACHED FILES

Request the files attached to this knowledgebase article.

Article last edited on: 2008-10-21 07:13:45

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential