ARM Technical Support Knowledge Articles

CANNOT RENAME THE DEVICES IN JTAG CHAIN

Applies to: uVision Debugger

Answer


Information in this knowledgebase article applies to:


SYMPTOM

In the ARM Target Driver Setup dialog, when I try to rename the devices in the JTAG chain, I have no radio buttons to select the device to which I want to connect.

CAUSE

A recent change in the JTAG Manual Configuration which requires users to exactly define the ARM core type debugged by ULINK.

RESOLUTION

Any "Device Name", in the JTAG Chain setup must begin with one of the following labels.

Therefore, you cannot name an LPC2378 "MyDevice", but you can name it "ARM7_MyDevice".

If you have (for example) an LPC3180, you need to name it "ARM926_MyDevice"

STATUS

Behavior changed in new version.

MORE INFORMATION

ATTACHED FILES

Request the files attached to this knowledgebase article.

Article last edited on: 2009-05-20 11:01:56

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential