ARM Technical Support Knowledge Articles

How do I trace the MCBSTM32E using the CoreSight High Density Probe?

Applies to: RealView ICE and Trace (RVI / RVT)

Answer

Configuring RVI and RVD to trace the MCBSTM32E using the CoreSight High Density Probe (CSHDP) consists of two basic procedures:

  1. Enable SWD (Serial Wire Debug) and SWJ (Serial Wire JTAG) when configuring the connection.
  2. Enable trace in RVD, by modifying configuration registers on the target.

These procedures are described in full in the attached PDF.

CSHDP_MCBSTM32E_trace.inc is the RVD script shown in the article.

Attachments

CSHDP_MCBSTM32E_trace.inc
howToTraceMCBSTM32E.pdf

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential