ARM Technical Support Knowledge Articles

Does PL330 wait for a 'ready' signal when executing a DMASTP instruction?

Applies to: PL330 AXI DMA Controller

Answer

The correct operation of PL330 is to write data immediately when executing a DMASTP. It will only wait for a 'ready' signal when a DMAWFP instruction is executed.

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential