ARM Technical Support Knowledge Articles

"Invalid ROM Table" on STM32 Device

Applies to: ULINK USB-JTAG Debugger

Answer


Information in this knowledgebase article applies to:


PROBLEM

When trying to download to my STM32 device, using ULINK2, ULINK-ME or ULINKPro, I get the following message:

Invalid ROM Table

The ULINK-ME/ULINK2 and ULINKPro adapters have worked with this board in the past. How can get downloading to work again?

SOLUTION

For ULINK2, ULINK-ME and ULINKPro debug adapters, make sure the Connect and Reset Options in Options For Target — Debug — Settings are set as follows:

After saving these options, cycle power on the target device, then try the download again. Your application should download as before.

MORE INFORMATION

SEE ALSO

ATTACHED FILES

Request the files attached to this knowledgebase article.

Article last edited on: 2012-01-26 12:58:08

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential