ARM Technical Support Knowledge Articles

CONNECTING ULINK2 TO TI/LUMINARY BOARD

Applies to: ULINK USB-JTAG Debugger

Answer


Information in this knowledgebase article applies to:


QUESTION

What is the best way to connect ULINK2 to the TI/Luminary EK-LM3S9B9x Evaluation boards?

ANSWER

Use the 10-pin ARM connector and 10-pin cable supplied with ULINK2 to connect directly to the JTAG/SWD connector on the EK-LM3S9B9x board.

You may power the EK-LM3S9B9x board directly from J5, or via the ICDI board. Just be sure to set SW1 (WARNING: REMOVE POWER from the EK-LM3S9B9x board before changing SW1) to USB if powering from J5, or to EXT if powering from the ICDI board.

SEE ALSO

ATTACHED FILES

Request the files attached to this knowledgebase article.

Article last edited on: 2010-12-15 12:53:40

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential