ARM Technical Support Knowledge Articles

How do I load symbols for an image already resident in flash using RVD?

Applies to: RealView Developer Kit (RVDK) for OKI, RealView Development Suite (RVDS)

Answer

If your image is already programmed into flash you can simply load the symbols for this image to allow you to debug at source level. To do this in RVD select: Target --> Load Image and ensure the Symbols Only checkbox is selected.

Article last edited on: 2011-08-16 17:03:51

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential