ARM Technical Support Knowledge Articles

Why do I have problems executing or stepping images in flash?

Applies to: RealView Developer Kit (RVDK) for OKI

Answer

If you have just used "Target -> Load image..." to load your application into flash memory (or loaded "Symbols Only" for an image already resident in flash) you should reset the Program Counter to the image entry point before attempting to step or run the image in RVD.

From the RVD main menu select: "File --> Set PC to Entry Point".

Article last edited on: 2008-09-09 15:47:26

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential