ARM Technical Support Knowledge Articles

Why do I see "post connect" error when I try to connect to RVI-ME?

Applies to: RealView Developer Kit (RVDK) for OKI

Answer

If there has been a failure to write to flash memory correctly in a previous debug session you may see persistent "post connect" errors when you try to connect to your target using RVI-ME.

In order to recover from this state you seem to need to close down RVD and power cycle RVI-ME and the target.

Article last edited on: 2008-09-09 15:47:26

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential