ARM Technical Support Knowledge Articles

Non-stop Semihosting or the Channel Viewer or the Debug Comms Channel doesn't work

Applies to: Multi-ICE

Answer

You cannot use the Channel Viewer and DCC semihosting ($semihosting_enabled = 2) at the same time. Choose one or the other.

This may not work either if you are using a core with a rev. C or earlier AMBA wrapper. Early versions of the Atmel AT91 chip suffer from this problem. If DCC semihosting doesn't work, try normal semihosting instead ($semihosting_enabled = 1)

For more information about this problem, see section 4.3.7 of the Multi-ICE v2.2 User Guide.

Article last edited on: 2008-09-09 15:47:30

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential