ARM Technical Support Knowledge Articles

When designing development boards what style JTAG connector should I use?

Applies to: Multi-ICE, RealView ICE and Trace (RVI / RVT)

Answer

For new designs we recommend customers to use the new 20-pins JTAG connector. The pin-out of this connector is described in Appendix F of the Multi-ICE v2.2 User Guide.

If your board has a 14-pin JTAG connector, you can use a 20-pin to 14-pin adaptor board to connect Multi-ICE or RealView ICE. For more information see the FAQ entry: My board has a 14-pin JTAG connector. Can I use Multi-ICE or RealView ICE with it?

Article last edited on: 2008-09-09 15:47:30

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential