ARM Technical Support Knowledge Articles

Is there any way of setting up trace points in the same way as setting breakpoints i.e. by using the source window?

Applies to: ARM Developer Suite (ADS), Trace Debug Tools (TDT)

Answer

This functionality is available in RVD, though not directly in AXD. However you can achieve similar functionality by noting the address of the instruction of interest, then configuring the ETM to capture trace from that address using the standard trace capture configuration dialog.

Article last edited on: 2008-09-09 15:47:32

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential