ARM Technical Support Knowledge Articles

How can I change the size of the MultiTrace trace capture buffer?

Applies to: Trace Debug Tools (TDT)

Answer

It is not possible to manually change the size of the trace capture buffer when using MultiTrace. The TPA configuration dialogue will allow you to specify a different value, but the MultiTrace unit will always capture the greatest amount of data possible according to the current trace capture settings.

Article last edited on: 2008-09-09 15:47:33

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential