ARM Technical Support Knowledge Articles

What JTAG connector should I specify if I wish to debug with RealView ICE?

Applies to: Multi-ICE, RealView ICE and Trace (RVI / RVT)

Answer

The RVI JTAG connector is a 20-way box header 10x2 2.54mm designed for  a standard 20-way IDC connector on the target.

This is a standard part and is available from many manufacturers. The connectors fitted on Integrator boards are from Toby's 302 Series, part number 302-S-20-D1S1 (see www.toby.co.uk).

Article last edited on: 2009-05-13 10:04:24

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential