ARM Technical Support Knowledge Articles

Can I use the ARM926 with a single-layer AHB system?

Applies to: ARM926EJ-S

Answer

Applies to : ARM926EJ-S

Yes, this is possible, however this is not recommended as the ARM926EJ-S has dual AHB interfaces for the data and instruction busses so you will not get optimal performance by doing this, data accesses may get stalled by instruction accesses and vice versa.

See also : ARM926EJ-S Technical Reference Manual (2MB PDF)

Article last edited on: 2008-09-09 15:47:43

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential