ARM Technical Support Knowledge Articles

Which ARM9EJ-S core should I use for ETM9 validation?

Applies to: ETM9

Answer

Applies to: ETM9

The ETM9 validation tests were written to run on an ARMEJ-S Rev0 core.

You will not be able to use an ARM9EJ-S Rev1 core because it does not have the following signals which are tested: ETMInMREQ, ETMIKILL, ETMISEQ.

DSM data for ARM9EJ-S Rev0 is delivered with the ETM9 deliverables.

Article last edited on: 2008-09-09 15:47:43

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential