ARM Technical Support Knowledge Articles

Which validation tests should I run for my configuration?

Applies to: ETM7, ETM9

Answer

Applies to: ETM7/ETM9

You should only run the validation tests which are appropriate for the configuration of ETM you are validating. This is ensured by using the “-config <your_config>” option when submitting validation tests.

For example, use the “-config etmSmall” option to run only the tests written for a small ETM when validating a small ETM.

 

Article last edited on: 2008-09-09 15:47:43

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential