ARM Technical Support Knowledge Articles

How do I run validation for the medium-plus configuration of ETM9?

Applies to: ETM9

Answer

Applies to: ETM9

Use the “-config etmMedium” option.

This will cause the same tests as for the medium configuration to be run. However, there will be marked differences in the results. Some tests which caused the FIFO in the medium configuration to overflow, and returned the “FIFO OVERFLOW” completion code, will return the “ETM TRC OK” message. Because the FIFO in the medium-plus configuration is larger, there will be no overflow in most cases.

The log files generated will have the same names as when the tests were run for a medium configuration. If running validation on both configurations, ensure that one set of log files are re-named, before running validation on the other configuration.

 

Article last edited on: 2008-09-09 15:47:43

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential