ARM Technical Support Knowledge Articles

Can we use PL351 low power mode using APB control even if AXI interface low-power signals are tied to inactive level (csysreq=1, cclken=0)?

Applies to: PL351 NAND Flash Memory Controller

Answer

A request to enter low-power mode in PL351 may be made either via the AXI-C interface or through programming via APB interface.

Article last edited on: 2008-11-05 08:30:40

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential