ARM Technical Support Knowledge Articles

Why do I get a 'Configuration item not supported' warning in RVD?

Applies to: RealView Development Suite (RVDS), RealView ICE and Trace (RVI / RVT)

Answer

RealView Debugger (RVD) may report the following warning message when trying to connect to a hardware target using RealViewICE (RVI):

Warning: 0x05050000: Configuration item not supported.

The warning message is triggered by a version mismatch between the current saved RVI configuration file (.rvc), the host-side RVI software version and the RVI firmware on the RVI hardware.

As a result of the above mismatch, you may also see 'General Error' in the Connect to Target window.

To fix this problem, please ensure that:

  • Your host-side RVI software version matches the version of RVI firmware you are using
  • You re-configure and save your ARM target configuration using the RVConfig window.

Article last edited on: 2011-08-16 20:19:02

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential