ARM Technical Support Knowledge Articles

How do I use VFP operations on the RTSM models?

Applies to: RealView Development Suite (RVDS)

Answer

In order to access the VFP registers, you will need to enable VFP in the core model (this is disabled by default).

To do this:

  • Open the "Run..." dialog
  • Add "--parameter $COREINST.vfp-enable_at_reset=1" to the "Extra commands" field
  • Apply the changes and run

 

 

Article last edited on: 2009-01-27 11:27:33

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential