ARM Technical Support Knowledge Articles

LOCATING FUNCTIONS AT ASCENDING ADDRESSES

Applies to: BL51 Code-banking Linker/Locator

Answer


Information in this article applies to:


QUESTION

When I link my C51 application, I would like to locate the functions in a source module in ascending order starting at a specific address. I know I can use the linker CODE directive to do this for each individual function, but can I do it for all the functions in a module?

ANSWER

No. This is not possible with C51 Version 5. It has been added in C51 V6.01. Refer to BL51: USING WILDCARDS IN SEGMENT NAMES for more information.

SEE ALSO

Article last edited on: 2004-05-05 20:29:41

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential