ARM Technical Support Knowledge Articles

OPENS WRONG HEADER FILE

Applies to: uVision (Version 1) IDE

Answer


Information in this article applies to:


QUESTION

In uVision, I compiled my files, and got error messages. I opened the error file and clicked on the error, but the cursor couldn't point to an error in my header file. It opened a file with the same name as my header file, but the file is empty. It is not opening the correct file, because the real header file is full of stuff. If I open the header file myself, then the cursor will point to the error, but I have to be careful to open the header file after opening the error file.

ANSWER

uVision got confused, it lost the path to the file. It knew it had to open one, so it created a fake one to open. To fix this, close all files, close the project, and exit uVision. Then restart uVision, open the project, and proceed normally.

Article last edited on: 2004-05-08 14:16:28

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential