ARM Technical Support Knowledge Articles

INTERNAL ERROR OCCURRED READING RETVAL FILE

Applies to: uVision (Version 1) IDE

Answer


Information in this article applies to:


QUESTION

Whenever I try to build my project using uVision, the following error appears in a dialog box.

An inteneral error occured while translating C:JUNK.C. The return value file could not be read.

What's wrong?

ANSWER

This error occurs when uVision cannot read the return values from the C compiler or Assembler. These values are saved in a temporary file that is created in your TEMP directory. This is where the TMP or TEMP environment settings point. Check these settings to make sure they point to valid directories. If you disabled automatic path specification determination in the Environment Settings (in uVision), you must MANUALLY specify theTEMP directory. If a valid directory is NOT entered here, this error will occur.

Article last edited on: 2004-05-13 20:36:01

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential