ARM Technical Support Knowledge Articles

V1.31 UPDATE CRASHES

Applies to: uVision (Version 1) IDE

Answer


Information in this article applies to:


QUESTION

I just downloaded the uVision V1.31 Update and ran the SETUP.EXE program. It runs up to 100% and then just locks up. If I exit the installation program, uVision doesn't work anymore. It reports that there are no toolsets available and just exits. Is there a fix for this?

ANSWER

Yes. This problem happens only on a few machines and only with the SETUP program from the install disk. We have corrected the installation program and it is now on the world wide web. Please re-download the update from the following URL:

http://www.keil.com/update/

and run the new SETUP program.

Article last edited on: 2004-05-20 20:15:11

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential