ARM Technical Support Knowledge Articles

CONNECTING TO A TERMINAL DOESN'T WORK

Applies to: MON166 Target Monitor

Answer


Information in this article applies to:


SYMPTOMS

I have installed the MON166 monitor in ROM in my C167 hardware. However, I can't seem to connect to the monitor with my terminal. What am I doing wrong?

CAUSE

MON166 is meant to connect with the dScope debugger or the uVision debugger. A special protocol is used which is difficult to emulate with only a terminal.

RESOLUTION

Use dScope or the uVision Debugger to connect with your target hardware. The debugger will route your serial output to a window. Since the communication with the monitor uses a protocol, anything that doesn't use this protocol MUST be your serial I/O.

Article last edited on: 2004-06-16 16:51:18

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential