ARM Technical Support Knowledge Articles

ERROR 22 (NO CODE MEMORY AT ADDRESS ????H)

Applies to: MON51 Target Monitor

Answer


Information in this article applies to:


QUESTION

I'm using the Keil Debugger to download my program using the MON51 monitor in my target hardware. When the debugger starts downloading my program, I receive the following error message:

ERROR 22 (NO CODE MEMORY AT ADDRESS 0045H)

Why do I receive this error?

ANSWER

When the monitor downloads your program to the target hardware, it writes to XDATA and reads from CODE to confirm that each byte was written correctly.

This message indicates that the monitor wrote a value to address X:0045h, read the value back from C:0045h, and the two values were different. So, the code that was downloaded and written to XDATA memory could not be read from the corresponding CODE address. When your program gets to address 0045h, it will not execute the instruction that it should.

Usually, this error indicates that you do not have von Neumann memory at the specified address.

One solution is to use the debugger to connect to the monitor without loading a program. Then, change the XDATA memory contents and view the CODE memory to see if it changes. If it does not, then there is a problem in your hardware or you have an inaccurate memory map.

MORE INFORMATION

Article last edited on: 2005-06-01 12:52:03

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential