ARM Technical Support Knowledge Articles

PROBLEMS WITH CODE BANKING AND SECONDS DIS

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

I have found several problems with the uVision debugger.

  1. My program uses bank switching with two code banks above 5000h. Everything below that is common code. I step through the program and step into a common code function from a banked function. When I step out of the common function to return to the banked code, the debugger gets lost. The code window shows an address like B00:0x9000 prior to the call to the COMMON function. Upon return, it shows C:0x9003 with all NOP instructions. I also get memory violation errors.
  2. The SECS display in the Regs window stays at 0 and does not update.

RESOLUTION

These problems have been corrected. Download and install C51 version 6.10 or later. You may download the latest updates from the Keil Website.

ATTACHED FILES

Request the files attached to this knowledgebase article.

Article last edited on: 2005-07-19 10:30:58

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential