8.3.1. Connector orientation

The connector can be oriented on the target system as Figure 8.1 shows. This shows the view from above the PCB with the trace connector mounted near to the edge of the board. This enables the TPA to minimize the physical intrusiveness of the target interconnect, that can be PCB-to-PCB, to ensure signal integrity.

Figure 8.1. Recommended connector orientation

To view this graphic, your browser must support the SVG format. Either install a browser with native support, or install an appropriate plugin such as Adobe SVG Viewer.


Copyright © 1999-2002, 2004-2009, 2011 ARM Limited. All rights reserved.ARM IHI 0014Q
Non-ConfidentialID101211