8.2. Target connector pinouts

This section contains details of the target system connector pinouts as follows:


The target connector pinout described in release C or later of the ETM specification is changed from that given in releases A and B.

All 38 pins are specified in the tables in this section.

The connector supports:

In multiplexed mode, each pin carries two ETM signals. In demultiplexed mode, each signal is split across two pins.

Trace port clocking modes describes the port modes.

Copyright © 1999-2002, 2004-2009, 2011 ARM Limited. All rights reserved.ARM IHI 0014Q