8.1. Target system connector

The specified target system connector is the AMP Mictor connector. For high-speed tracing through a demultiplexed, half-speed port using 8 or 16 TRACEPKT bits, two Mictor connectors are required.

The AMP Mictor connector is a high-density matched-impedance connector. This connector has several important attributes:

Table 8.1 shows the AMP part numbers for the four possible connectors.

Table 8.1. Connector part numbers

AMP part number

Description

2-767004-2

Vertical, surface mount, board to board/cable connector

767054-1

Vertical, surface mount, board to board/cable connector

767061-1

Vertical, surface mount, board to board/cable connector

767044-1

Right angle, straddle mount, board to board/cable connector


The choice of connector used depends on factors such as board thickness and cost. Contact AMP connector distributors for details of connectors to meet application-specific requirements.

Copyright © 1999-2002, 2004-2009, 2011 ARM Limited. All rights reserved.ARM IHI 0014Q
Non-ConfidentialID101211